NEC Univerge sv8500 Manual page 2311

5. Setting ToS value for DRS session:
This command is used to set quality of service data for DRS session (for Proprietary Protocol mode only).
PRECEDENCE setting by specifying each bit or VALUE setting by entering the setting value directly can
be selected. Select VALUE setting when specifying Codepoint of Diffserv. Usually use this command data
in default setting.
VS-32> SET DRSTOS P1
• When PRECEDENCE is selected:
VS-32> SET DRSTOS PRECEDENCE
PRECEDENCE (0-7): 6
DELAY (0/1): 0
THROUGHPUT (0/1): 0
RELIABILITY (0/1): 0
COST (0/1): 0
DRS TOS setting succeeded. (0xC0)
Result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
followed by the prompt. The meaning of 1-byte data is shown below:
Prec.
• When VALUE is selected:
VS-32> SET DRSTOS VALUE
TOS (00-FF): C0
DRS TOS setting succeeded. (0xC0)
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
D T R C
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
P1: PRECEDENCE/VALUE
Enter PRECEDENCE following the sub command.
Precedence: 0-7 (low-high) (default=6)
Delay: 0/1=Normal (default)/Low delay
Throughput: 0/1=Normal (default)/High throughput ON
Reliability: 0/1=Normal (default)/High reliability ON
Cost: 0/1= Normal (default)/Cost precedence ON
Result is shown.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
Enter VALUE following the sub command.
Specify the value directly in the range of 00-FF (default=C0).
Result is shown.
VOL.2-2058