NEC Univerge sv8500 Manual page 2495

1.4 Installation Procedure Installation Procedure
1.4.1 Basic Installation Procedure
Follow the procedure below to install the DtermIP.
STEP 1: Make sure that AC/DC adapter is not connected to the DtermIP. (When powered HUB (PoE switch)
is used, skip this step.)
STEP 2: Prepare LAN cable (10BASE-T/100BASE-TX straight-through) for connecting the DtermIP to net-
work device such as HUB, PoE Switch.
STEP 3: Connect the DtermIP to the network device using the LAN cable.
STEP 4: Connect a PC to the DtermIP if required.
STEP 5: Connect the AC/DC adapter to the terminal. (When powered HUB (PoE switch) is used, skip this step.
For more information about the powered HUB (PoE switch), refer to
STEP 6: Set the configuration data of the terminal. (See Chapter 4 Configuration Setup.)
Note:
The PC connector marked with an "X" is exclusively for a PC, not for a DtermIP
Network Device
(PoE Switch etc.)
DtermIP Connecting Diagram
(10BASE-T/100BASE-TX
to PC
PC
(Optional Connection)
DtermIP
How to Connect LAN Cable to DtermIP
to LAN
DC 24V
(=)
+ -
Note
REAR VIEW
10BASE-T/100BASE-TX
(Straight-through) Cable
LAN Cable
straight-through)
LAN
to LAN
Swithing HUB
to PC
RJ-45 Connector
Pin Assignment
(X)
VOL.3-8
CHAPTER 1 TERMINALS
APPENDIX A.)
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
PC