NEC Univerge sv8500 Manual page 2310

3. Setting DNS Server:
This command is used to set whether to use DNS server (required for SIP mode only).
VS-32(SIP)> SET DNS_SW
DNS Interface (ENABLE/DISABLE) [ENABLE]: ENABLE
DNS IP Address [0.0.0.0]: 10.41.1.150
DNS Server setting succeeded.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
When DISABLE is selected, the setting line of DNS IP Address is not displayed.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
4. Setting IP address and port number of DRS:
This command is used to set IP address and port number of DRS (for Proprietary Protocol mode only). Usu-
ally use the default port number 3456 when the setting is not changed in the Telephony Server side. IP ad-
dress can be set in SETUP TP command. Port number can be set in SET PORTNUMBER command.
VS-32> SET DRSADDRESS
Please enter DRS unit (1:Primary/2:Secondary/
3:Tertiary/4:Fourth):1
DRS server address (ex. 111.22.3.4):
10.41.1.200
DRS port number (ex. 3456): 3456
DRS server address set complete.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
ENABLE=DNS server is used
DISABLE=DNS server is not used (default)
Enter the IP address of DNS server
(e.g. 10.41.1.150)
Result is shown.
Enter the unit of DRS. (Usually 1: Primary is
used.)
Enter the IP address of DRS Note 1
(e.g. 10.41.1.200)
Enter the port number of DRS
(default = 3456)
Result is shown.
VOL.2-2057