NEC Univerge sv8500 Manual page 2302

Setting Communication Speed of LAN Interface:
--- Ethernet Speed set ---
Current LAN Speed: auto
Change LAN Speed? [Y(change)/N(current)/Q(quit)]: y
Input new Speed [1(AUTO)/2(100M)/3(10M)]: 2
Input new DUPLEX [F(full)/H(half)]: f
Line 2: The current setting is displayed.
Line 3: Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Line 4: Select the communication speed of LAN interface
1=Auto negotiation (default)
2=100Mbps fixed mode
3=10Mbps fixed mode
Line 5: Select the Duplex mode of LAN interface (*not required for auto negotiation)
F=Full duplex mode
H=Half duplex mode
Save the assigned configuration data at the last of SETUP TP command to complete network setting.
**Don't power off in progress**
Do you save the configuration data? [Y/N]: y
Configuration data has been saved.
Re-starting is required for making a setup reflect!!
TP mode setting succeeded.
Line 2: Asked whether to save the assigned data.
Y=Save
N=Discard
Line 3: Result is displayed.
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
VOL.2-2049