NEC Univerge sv8500 Manual page 3103

5.3 Ping
On the Ping Menu, send Ping to the specified IP address.
STEP 1: Select "3. Ping" by pressing "3" on the Online Monitoring Main screen.
Press Exit key to go back to the normal operation display.
Note:
STEP 2: The display changes as follows:
When Network Interface (NI) is running, the screen of (1) appears.
Enter the destination IP address, and then press OK key.
When Network Interface (NI) is not running, the screen of (2) appears.
Even If the notification that Network Interface (NI) starts running is received while displaying (2),
the notification is ignored. To display (1), press Prev key to go back to the Online Monitoring screen,
and then press "3" key again.
(1) When Network Interface (NI) is running:
PingAdr? XXX.XXX.XXX.XXX
' '
Use * For .
BK
STEP 3: After pressing OK key on the screen of Step 2 (1), ping command is sent to the specified IP address. At
this time the destination IP address and the ping sending result are displayed on the LCD. After the
ping is sent four times, "Complete" is displayed in the second line of the LCD. Also, "Prev" and
"Retry" keys appear on the LCD.
"Prev" key
"Retry" key
Online Monitoring Main Screen
1.QoS
2.System Information
3.Ping
Up Down
Prev
OK
: To go back to the Online Monitoring Main screen.
: When Network Interface (NI) is running, the screen of Step 2 (1) appears again.
When Network Interface (NI) is not running, the screen of Step 2 (2) appears.
VOL.3-616
CHAPTER 4
Exit
(2) When Network Interface (NI) is not running:
DHCP Server Down
CONFIGURATION SETUP
Prev