NEC Univerge sv8500 Manual page 2511

1.6.3 Feature Description of 16LD ADM when Used as DSS Mode
This section explains the function of 16LD ADM unit when it is used as DSS mode. 16LD ADM can operate as
an option unit of DtermIP. In DSS mode, 16LD ADM provides additional 16 feature programmable key with
LCD display and it can operate as a line key or DSS key (To be assigned by ADKS command). It can be used
either as a multi line key or a function key when it is used in line key mode (To be assigned by AKYD com-
mand). Key information can be displayed on LCD. It has a USB port as a personal computer interface. The func-
tion corresponding with DSS mode are as follows. AKYD command only supports 32 buttons in maximum, so
connection is only available to the terminal with 16 feature programming keys in maximum.
<Terminal connectability>
Refer to the table below for the terminal connectability.
PBX Model-B Non-IP TEL (
Dterm
PBX Model-B
PBX Model-B Back-Light TEL (
INASET
Symbols:
X: Available with factory setting
C: Conditionally available (Bit switch setting is required)
N: Not available
Terminal connectability
Series
Dterm Series i
)
IP
Dterm Series i
VOL.3-24
Name
DTR-8-2*(WH/BK) TEL
DTR-8D-2*(WH/BK) TEL
DTR-16D-2*(WH/BK) TEL
DTR-32D-1*(WH/BK) TEL
DTR-16LD-2*(WH/BK) TEL
ITR-8D-2*(WH/BK) TEL
ITR-16D-2*(WH/BK) TEL
ITR-8D-3*(WH/BK) TEL
ITR-16D-3*(WH/BK) TEL
ITR-32D-3*(WH/BK) TEL
ITR-16LD-3*(WH/BK) TEL
) DTR-16D(BL)-2*(WH/BK) TEL
ITR-320C-1*(BK) TEL
ITR-320G-1*(BK) TEL
ITR-240G-1*(BK) TEL
CHAPTER 1 TERMINALS
Connectability
X
X
X
N
X
C
C
C
C
N
C
X
C
C
C