NEC Univerge sv8500 Manual page 2347

[4] Open a DOS window; enter
key.
[5] Make sure that you get replies from the SR-MGC(E) (172.223.12.45, in this case).
[6] Run PCPro and login to the SR-MGC(E).
STEP 13: Test PCPro operation.
Make sure that you can use PCPro properly.
STEP 14: Assign office data for the SR-MGC(E) to the MGC.
With PCPro logging-in to the MGC, perform the CMNT command to assign office data for the SR-
MGC(E) belonging to the MGC.
For the procedure to assign the data, see
described as for a Two-Unit SR-MGC but the procedure is same as an SR-MGC(E).
STEP 15: Copy office data from the MGC to the SR-MGC(E).
Use the CMNT command to copy office data from MGC to SR-MGC(E).
The parameters in the CMNT command differ according to the software version of your system.
[For FP85-109 S6 or later version]
• Office Data Copy & Load: Perform the CMNT command; open the File Control tab. Select Of-
fice Data Copy & Load from PROCESS TYPE to copy the office data.
• Select All button: Click the Select All button to execute office data or program copy to all the
SR-MGCs in the network.
• Clear All button: Click the Clear All button to return all the SR-MGC Numbers to the state of
No Processing Request.
• Specifying SR-MGC: Specify the target SR-MGC number (0-255), the box of specified SR-
MGC number is displayed in yellow. And then click the Execute button.
To undo specifying SR-MGC, click the box again.
* The meanings of displayed data are as follow.
Indicated Color
Gray
White
Yellow
Blue
Green
Red
Magenta (Pink)
ping 172.223.12.45
<Data Assignment on the Telephony Server
Status of SR-MGC
SR-MGC Number is not accommodated
No processing request
On standby (Already requested to execute the process)
Under processing
Succeeded in processing
Failed in processing
Cannot execute, because SR-MGC is assigned as the
Backup node
VOL.2-2094
(SR-MGC(E) address); press the Enter
(MGC)>, which is
SR-MGC(E)