1.4.4
Password Setting
•
New Password Assignment
To assign a new password, follow the procedure below. Note that the password stored in System memory can
be assigned from the DtermIP/IP Enabled Dterm only.
When starting up Login Mode on IP terminal for the first time, Station Number is used for a password. If
Note:
an arbitrary number is set as Login Code by the ALGCL/ALGCN command, enter registered Login Code
instead of Station Number for a password.
The password assigned here is not for the line to be used, but for the terminal itself.
Note:
CHAPTER 4
VOL.3-431
CONFIGURATION SETUP