NEC Univerge sv8500 Manual page 2327

INIT
1. To initialize configuration data to the factory default setting:
Use this command only when required to reset the system data to default value.
• Proprietary Protocol mode
VS-32> INIT CONFIGDATA
*** Warning !! ***
This command initializes the configuration data.
This deletes the current setting.
Recommend to back up the setting.
Command execute or not? [Y/N]: y
Erase start...
Erase OK!
Write start...
Write OK!
Command complete.
You need to setup configuration data!!
• SIP mode
VS-32(SIP)> INIT CONFIGDATA
*** Warning !! ***
This command initializes the configuration data.
This deletes the current setting.
Recommend to back up the setting.
Command execute or not? [Y/N]: y
Initializes authentication key or not? [Y/N]: y
Erase start...
Erase OK!
Write start...
Write OK!
Command Complete.
You need to setup configuration data!!
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
VOL.2-2074
Asked whether to execute initialization.
Y=Initialize
N=Not execute
Writing to Flash ROM is executed.
Result is shown.
Asked whether to execute initialization.
Y=Initialize
N=Not execute
Asked whether to clear one time pass-
word and authentication data.
Y=Clear OTP/authentication data
N=Not clear OTP/authenticated data
Writing to Flash ROM is executed.
Result is shown.