NEC Univerge sv8500 Manual page 3125

6.2 Configuration Data Setting Procedure
This section explains the setting procedure of each configuration menu. The explanation covers the procedure
for [1] Configuration Setting on Terminal and [2] Configuration Setting by Web Programming.
LCD varies depending on the terminal type and the setting condition. The explanation for the configuration set-
ting procedure in the following sections goes with Standard LCD of DT730/DT730G Series and digit key oper-
ation.
DT750 Series
Maximum number
of lines displayed on
8 lines Note 1
LCD
Operation
Touch-sensitive
The maximum number of lines means the available number on condition that default value is applied for
Note 1:
font size setting.
DT710 Series without LCD/DT770G does not support [1] Configuration Setting on Terminal, therefore,
Note 2:
you need to set up DHCP server for the terminal to acquire an IP address before configuring the terminal.
And then, specify the terminal setting, referring to [2] Configuration Setting by Web Programming.
Refer to the operation manual of each terminal for the setting procedure using cursor key and software key.
Note:
6.2.1 IP Address of DT700 Series and SIP server
This menu assigns the IP address of terminal (only for without DHCP configuration) and the IP address (or
FQDN) of SIP server.
Assignment procedure depends on the system configuration. Select from the following three methods (
for configuration assignment.
"SIP server" used in this section refers to the Telephony Server. The Telephony Server acts as SIP server
Note:
where DT700 Series are registered.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
As for DT710 Series without LCD/DT770G, you have to follow the procedure of TYPE 1 or TYPE 2 using
Note 2:
Web Programming.
DT730G Series
(Color LCD) (Color LCD)
6 lines Note 1
Software key for "↑" and "↓"
panel (DT750
Series only)
Note 1
CHAPTER 4
DT730/
DT730G Series
(Standard
LCD)
3 lines Note 1
Digit key
Cursor key
VOL.3-638
CONFIGURATION SETUP
DT710 Series
w/ LCD
w/o LCD
(2-line LCD)
2 lines
-
Note 2
DT770G
-
Note 2
)
Note 2