NEC Univerge sv8500 Manual page 2940

1.4.10 How to Send Ping Packet
To send packets from the IP Enabled Dterm by using the Ping command, follow the procedure below.
When the IP addresses of the terminal and the destination is not set on the IP Enabled Dterm, Ping Packet
Note:
cannot be sent.
STEP 1: Open the User Menu by pressing "Hold" + "Transfer" + "*" + "#" on the terminal while indicating
time, an error message, or "DHCP Connecting.../DRS (1st) Connecting...".
When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connect-
Note:
ing..." will be displayed instead of "DRS(1st) Connecting...".
STEP 2: Open the Administrator Menu (Page 1) by pressing "Hold"+"#"+"0" on the User Menu. Select "0.
Next Page (P1 >> P2)" by pressing "0" on the Administrator Menu (Page 1).
STEP 3: The Administrator Menu (Page 2) is displayed. Select "1. Ping" by pressing "1" key.
STEP 4: The following Ping Menu is displayed. Select "2. Destination Address" by pressing "2" key.
[User Menu]
1.DHCP Mode
2.DRS Address Primary
Save
Up Down Cancel
[Administrator Menu (Page1)]
9.Language
0.Next Page (P1>>P2)
Exit
Up Down
[Administrator Menu (Page2)]
1.Ping
2.Music Select
Up Down
[Ping Menu]
1.Echo Request Start
2.Destination Address
Up Down Exit
VOL.3-453
CHAPTER 4 CONFIGURATION SETUP