NEC Univerge sv8500 Manual page 2846

DAP Replacement Procedure
For more information about each procedure, refer to the related part.
Note:
Check the following switch settings of each DAP.
Note 1:
a.) SN4046 DAPM-A (Analog DAP)
SW 60-61
•
SW 62
•
SW 63
•
b.) SN4044 DAPK-A (Digital DAP)
SW 70-71
•
SW 72
•
Detach the DCS front panel.
Remove the PWR/2M AMI/Champ cables.
Remove the screws.
Remove the DAP from DCS pulling the handle.
Confirm the switch settings of DAP card. Adjust the switch settings
of new DAP card to the removed card.
Insert the new DAP and fasten the screws.
Connect the cables.
Make sure the system operates normally.
Attach the front cover.
CHAPTER 2
START
Note 1
END
VOL.3-359
TERMINAL-RELATED DEVICES