NEC Univerge sv8500 Manual page 3243

STEP 18: The LCD displays the selected [Server Address] or [Server Port] setting screen.
- Setting 2nd - 4th Server Address
[2nd Server Address]
*'For'.'
0. 0.
BK Cancel
Note: The figure shows an example when "1. 2nd Server Address" is selected in [SIP Settings] menu.
Note: When Backup IP is in service, this data will be overwritten by obtained SIP Server address if DT700
Series obtains an IP address from DHCP server. If obtained data does not have a SIP Server address,
the existing data is maintained.
- Setting 2nd - 4th Server Port
[2nd Server Port]
0, 1024-65535
0
BK Cancel OK
Note: The figure shows an example when "4. 2nd Server Port" is selected in [SIP Settings] menu.
Note: When Backup IP is in service, this data will be overwritten by obtained SIP Server port number if
DT700 Series obtains an IP address from DHCP server. If obtained data does not have a SIP Server
port number, the existing data is maintained.
STEP 19: The LCD displays [SIP Settings] menu.
[SIP Settings]
1.2nd Server Address
2.3rd Server Address
3.4th Server Address
E
- Use "*" to separate each byte.
- Press the software key for "BK" to delete the input value.
0. 0
- Press the software key for "OK" when all settings are complete.
OK
- Use digit keys.
- It is possible to enter 0 or values between 1024-65535.
- Default value is 0.
- Press the software key for "OK" when all settings are complete.
Exit
VOL.3-756
CHAPTER 4 CONFIGURATION SETUP