NEC Univerge sv8500 Manual page 2277

• When DHCP server and DNS server are used
In this setting, because IP addresses are automatically distributed from DHCP server, it is not required to
set IP address on VS-32(Dual) side. Set the following data on VS-32(Dual):
• Communication Speed of LAN Interface
IP addresses listed below, however, need to be assigned on DHCP server side.
• IP address of Default Gateway
• IP address of DNS server
• Host name of SIP server
* Check the number of IP addresses saved in DHCP server is sufficient so as to get IP address of VS-32(Du-
al) anytime.
Assign the required DHCP option in Add Option Type dialog box as follows:
Note 1:
Class:
Name:
Data:
Array:
Code:
IP address of Default Gateway
IP address of DNS server
Host name
Domain name
IP address or host name of SIP server
IP address of the Telephony Server
Refer to DHCP Server in Volume 2 of this manual for more information on DHCP option setting.
VS-32(Dual) need not assign host name of SIP server in configuration setting because the host name as-
Note 2:
signed on DHCP server side is applied.
Note 2
Global
Not specified, but do not enter the same option name in duplicate (e.g. SP1)
IP address
Checked
See the table below.
OPTION NAME
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
CODE
003 Required when DHCP server is active.
006 Required when host name is assigned to code 120.
012 Invalid when code 015 is not assigned.
015 Invalid when code 012 is not assigned.
120
Either code 120 or 162 is required. Code 120
turns invalid when code 162 is assigned.
162
VOL.2-2024
Note 1
REMARKS