(b) Use telnet to reset SR S.
PCPro
First, reset the SR T by turning the PWR switch OFF
follows.
1) Use telnet to log on to the SR S.
telnet 172.16.253.1
2) Type "SV7000" twice for login and password, and then check to see that a prompt is changed.
login: SV7000
password:
[SV7000@SRMGC_SP~]#
3) Restart the SR S.
[SV7000@SRMGC_SP~]#sudo shutdown -r now
password:
If you want to perform the installation test, refer to
telnet
→
ON on the rear side. And then reset the SR S as
Type an IP address of SR S after the command.
Type "SV7000" for login account.
Type "SV7000" for password.
A prompt is changed to the root prompt.
Type "SV7000" for password.
Section 27.3.6, Installation
VOL.2-2183
SR-MGC
Type "sudo shutdown -r now".
Test.
SR-MGC