NEC Univerge sv8500 Manual page 2256

3. Port Numbers
The following provides the port number to be used in the system
Function
VS-32(Dual) ⇔
Telephony Server
P2P communication
Peer to Peer
Function
Registration
TP ⇔ SP
Note 1
iLP-PM
SP Internal
Control Port iLP-PM
Note 2
VS32(Dual)
SIP
⇔ SP
Ready
H.245
Negotiation
H.245
The packet between TP and SP ("TP ⇔ SP" in the table) does not flow over the network because both of
Note 1:
which are part of the Telephony Server.
The packet related to SP internal control port does not flow over the network.
Note 2:
Port Number in Proprietary Protocol mode
Port Number
(default)
Registration 3456
iLP-PM 60130
62000
control port
RTP start port 1024
H.245 start port 60000
Port Number in SIP mode
TP side
LAN Port Port Number
(default) (default)
LAN1 3456
LAN1 60130
-
-
-
-
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
TP side
How to Change Port Number
Default value can be changed by ADTM command.
Default value can be changed by ADTM command.
Default value can be changed by the configuration com-
mand SET PORTNUMBER.
Command to
Change Setting
ADTM
(Port Number only)
ADTM
(Port Number only)
- -
- -
- -
- -
VOL.2-2003
SP side
Port Number Command to
(default) Change Setting
22000 Cannot be changed
64105 ALIDL
64010 ALIDL
22001 ASPC
5060 Cannot be changed
22002 ASPC
22003 ~ 26000 ASPC