NEC Univerge sv8500 Manual page 3040

Digit
Key
1
1 1
2 a
3 d
4 g
5 j
6 m
7 p
8 t
9 w
0 0
* *
STEP 5: Press OK key and go back to the display of Step 2. Repeat Step 2-4 until all the necessary servers are
set.
STEP 6: When all the necessary data is set, press Exit key on the display of Step 2 to go back to the SIP Settings
Menu.
STEP 7: Press Exit key on the SIP Settings Menu and go back to the Main Menu.
STEP 8: Press Save key on the Main Menu to save the assigned data.
4.2.2.9 Register Destination (Server Address & URI)
Set IP address and URI of the register destination SIP server.
"RegistrarDestination" parameter is available for DtermIP (SIP) with Firmware Version 2.0.4.0 or later.
Note:
Do not set this parameter except when using Firewall NAT accommodating special SIP-NAT.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note:
tions" in INTRODUCTION of Installation Manual.
STEP 1: Select "2. Server Address & URI" by pressing "2" key on the SIP Settings Menu.
Key Entry Method
The Number of Times Key is Pressed
2 3 4
b c A
e f D
h i G
k l J
n o M
q r s
u v T
x y z
# . -
VOL.3-553
CHAPTER 4
5 6 7
B C 2
E F 3
H I 4
K L 5
N O 6
P Q R
U V 8
W X Y
_
CONFIGURATION SETUP
8 9
S 7
Z 9