A System Programming Codes (Expert Mode Codes; Introduction; Accessing System Administration - Siemens HiPath 3000 Series Service Documentation

Nur für den internen Gebrauch
A System Programming Codes (Expert Mode Codes)
A.1

Introduction

The workpoints with the two lowest internal station numbers (for example, 11 and 12 or 100 and
101) can be used to administer HiPath 3000 systems.
Programming is conducted in expert mode. This allows you to program features and settings
by inputting defined digit strings.
You must acknowledge error messages. When the system reports an error as a result of enter-
ing a previously used code, a code appears in the second line of the display. You can use this
code to go directly to the desired menu segment.
A.2

Accessing system administration

Users can access system administration by entering a user name (ID) and password (authen-
tication). Depending on the active password concept (refer to Section 12.7.1.3 for more details),
the procedure is as follows:
Table A-1 Starting System Administration (Service)
Step
1.
2.
3.
Page 12-113 contains an example of initial system administration via Assistant T after the sys-
tem is booted.
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Input
*95 Start system administration
XXXXX Enter user name:
●
●
XXXXX Enter password:
●
●
System Programming Codes (Expert Mode Codes)
Description
Fixed password concept: User name = 31994
Variable password concept: Individual user name
Fixed password concept: Password = 31994
Variable password concept: Individual password
pcodes.fm
Introduction
A-1