Displays And Mode Selector - Siemens CP 443-5 Basic Manual

4

Displays and Mode Selector

LEDs Displaying the Status of the CP
The 4 LED indicators on the front panel provide information on the status of the CP
as shown in the table below:
Table 4-1
INTF(red) EXTF(red)
Key:
Note
Read the explanations of the operating modes in the NCM S7 for PROFIBUS
manual /2/ under modes of operation.
CP 443-5 Basic for PROFIBUS / Manual Part B3 –
Release 11/2002
C79000-G8976-C161-03
www.gkbpx.com
RUN(green) STOP
(yellow)
on off
Displays and Mode Selector
CP Operating Mode
Starting up (STOP->RUN)
Running (RUN)
Stopping (RUN->STOP)
Stopped (STOP)
STOP due to internal error (for example
CP not configured)
Waiting for firmware update (duration 10
seconds after power on)
Waiting for firmware update (CP
currently has an incomplete firmware
version).
RUN and PROFIBUS bus errors
Module fault / system error
flashing
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
B3–11