Copy Debug - Allied Telesis AT-x510-28GTX Command Reference Manual

F C M
ILE AND ONFIGURATION ANAGEMENT

COPY DEBUG

copy debug
Overview This command copies a specified debug file to a destination file. Specify whether
the destination is Flash or USB when saving the software to the local filesystem.
copy debug {<destination-name>|debug|flash|nvs|scp|tftp|usb}
Syntax
{<source-name>|debug|flash|nvs|scp|tftp|usb}
Mode Privileged Exec
Example To copy debug output to a USB storage device with a filename "my-debug", use
the following command:
awplus#
Output Figure 2-2:
Related delete debug
Commands
move debug
C613-50102-01 REV C
C
OMMANDS
Parameter
<destination-name>
<source-name>
copy debug usb:my-debug
CLI prompt after entering the copy debug command
Enter source file name []:
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The filename and path where you would like the debug
output saved. See Introduction
syntax.
The filename and path where the debug output originates.
See Introduction on page 101 for valid syntax.
on page 101 for valid
116