Copy Debug - Allied Telesis IE340 Series Command Reference Manual

F C M
ILE AND ONFIGURATION ANAGEMENT

COPY DEBUG

copy debug
Overview This command copies a specified debug file to a destination file.
copy debug {<destination-name>|debug|flash|nvs|scp|tftp|usb}
Syntax
{<source-name>|debug|flash|nvs|scp|tftp|usb}
Mode Privileged Exec
Example To copy debug output to a file on flash called "my-debug", use the following
command:
awplus#
To copy debug output to a USB storage device with a filename "my-debug", use
the following command:
awplus#
Output Figure 3-2:
Related delete debug
commands
move debug
C613-50631-01 Rev A
C
OMMANDS
Parameter
<destination-name>
<source-name>
copy debug flash:my-debug
copy debug usb:my-debug
CLI prompt after entering the copy debug command
Enter source file name []:
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
The filename and path where you would like the debug
output saved. See Introduction
syntax.
The filename and path where the debug output originates.
See the Introduction to this chapter for valid syntax.
on page 137 for valid
151