Show Ip Route Summary - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

To administratively control the traffic destined to a particular network and prevent it from being
forwarded through the router, you can configure a static reject route on the router. Such traffic
would be discarded and the ICMP destination unreachable message is sent back to the source. This
is typically used for preventing routing loops. The reject route added in the RTO is of the type
OSPF Inter-Area. Reject routes (routes of REJECT type installed by any protocol) are not
redistributed by OSPF/RIP. Reject routes are supported in both OSPFv2 and OSPFv3.
The following shows example CLI display output for the command.
(Switch) #show ip route
Route Codes: R - RIP Derived, O - OSPF Derived, C - Connected, S - Static
B - BGP Derived, IA - OSPF Inter Area
E1 - OSPF External Type 1, E2 - OSPF External Type 2
N1 - OSPF NSSA External Type 1, N2 - OSPF NSSA External Type 2
C 1.1.1.0/24 [0/1] directly connected, 0/11
C 2.2.2.0/24 [0/1] directly connected, 0/1
C 5.5.5.0/24 [0/1] directly connected, 0/5
S 7.0.0.0/8 [1/0] directly connected, Null0
OIA 10.10.10.0/24 [110/6] via 5.5.5.2,
C 11.11.11.0/24 [0/1] directly connected,
S 12.0.0.0/8 [5/0] directly connected, Null0
S 23.0.0.0/8 [3/0] directly connected, Null0

show ip route summary

Use this command to display the routing table summary. Use the optional all parameter to show
the number of all routes, including best and non-best routes. To include only the number of best
routes, do not use the optional parameter.
Format
show ip route summary [all]
Modes • Privileged EXEC
• User EXEC
Term Definition
Connected The total number of connected routes in the routing table.
Routes
Static Routes Total number of static routes in the routing table.
RIP Routes Total number of routes installed by RIP protocol.
OSPF Routes Total number of routes installed by OSPF protocol.
Routing Commands
Managed Switch CLI Manual, Release 8.0
00h:00m:01s,
0/11
v1.0, July 2009
0/5
4-18