Default
0 or link speed (MTU value (1500))
Format
ipv6 mtu <1280-1500>
Mode
Interface Config
no ipv6 mtu
This command resets maximum transmission unit value to default value.
Format
no ipv6 mtu
Mode
Interface Config
ipv6 nd dad attempts
This command sets the number of duplicate address detection probes transmitted. Duplicate
address detection verifies that an IPv6 address on an interface is unique.
Default
1
Format
ipv6 nd dad attempts <0 - 600>
Mode
Interface Config
no ipv6 nd dad attempts
This command resets to number of duplicate address detection value to default value.
Format
no ipv6 nd dad attempts
Mode
Interface Config
ipv6 nd managed-config-flag
This command sets the "managed address configuration" flag in router advertisements. When the
value is true, end nodes use DHCPv6. When the value is false, end nodes automatically configure
addresses.
IPv6 Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
7-15