Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.51 neighbor optionalcap
This command enables the specified capability for the peer connection. Optional
capabilities allow a BGP4 speaker to be aware of the protocol extensions capabilities of a
BGP4 neighbor. The possible optional capabilities are
and
confed,
all.
the BGP peer must be reset before the changes take effect.
Default
Format
Mode
14.8.51.1 no neighbor optionalcap
This command disables the specified capability for the peer connection
Format
Mode
14.8.52 neighbor remote-as
This command assigns the remote Autonomous System (AS) Number for the peer. The
range for this field is 1 to 65535
reset before the changes take effect.
Format
Mode
14.8.52.1 no neighbor
This command removes the remote Autonomous System (AS) number assignment for the
peer. After executing this command, the BGP peer must be reset before the changes will
take effect.
Format
Mode
14.8.53 neighbor route-reflector-client
This command enables the route reflector client. A route reflector client relies on a route
reflector to re-advertise its routes to the entire AS. The possible values for this field are
and
enable
disable.
the changes will take effect.
Routing Commands
Each capability may be enabled or disabled. After executing this command,
all capabilities are disabled
neighbor <peeripaddr> optionalcap
Router BGP Config
no neighbor <peeripaddr> optionalcap
Router BGP Config
After executing this command, the BGP peer must be
.
neighbor <peeripaddr> remote-as <peerasnumber>
Router BGP Config
no neighbor <peeripaddr> [remote-as]
Router BGP Config
After executing this command, the BGP peer must be reset before
v1.0, December 2005
multiproto, routereflect, community,
14-87