Fspf Cost - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Fibre Channel Commands

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

fspf cost

To configure FSPF link cost for an FCIP interface, use the fspf cost command. To revert to the default

value, use the no form of the command.

Syntax Description

vsan vsan-id

Command Default

1000 seconds for 1 Gigabits per second interfaces.

500 seconds for 2 Gigabits per second interfaces.

Command Modes

Interface configuration mode

Command History

4.0(0)N1(1a)

Usage Guidelines

This command is not applicable to virtual Fibre Channel interfaces.

FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database,

and then chooses the path with a minimal cost. The cost associated with an interface can be changed

using the fspf cost command to implement the FSPF route selection.

The following example configures the FSPF link cost on an FCIP interface:

switch(config)# interface fc 2/1

switch(config-if)# fspf cost 5000 vsan 1

Related Commands

show fspf interface

show interface fc

fspf cost link-cost vsan vsan-id

no fspf cost link-cost vsan vsan-id

Enters FSPF link cost in seconds. The range is 1 to 65535.

Specifies a VSAN ID. The range is 1 to 4093.

Modification

This command was introduced.

Displays information for each selected interface.

Displays an interface configuration for a specified Fibre Channel interface.

Cisco Nexus 5000 Series Command Reference