Cdp Enable - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

cdp enable

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

To enable the Cisco Discovery Protocol (CDP) on an Ethernet interface, use the cdp enable command.

To disable CDP on the interface, use the no form of this command.

Syntax Description

This command has no arguments or keywords.

Command Default

Command Modes

Interface configuration mode

Command History

4.0(0)N1(1a)

This example shows how to enable CDP on an Ethernet interface:

switch# configure terminal

switch(config)# interface ethernet 1/1

switch(config-if)# cdp enable

Related Commands

show interface

Cisco Nexus 5000 Series Command Reference

no cdp enable

Modification

This command was introduced.

Displays the interface configuration information.

Ethernet Commands

Do you have a question about the AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?