Show Spanning-Tree Interface - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show spanning-tree interface

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show spanning-tree interface
To display information on the STP interface status and configuration of specified interfaces, use the
show spanning-tree interface command.
Syntax Description interface type slot/port |
port-channel number
active
brief
detail
cost
edge
inconsistency
priority
rootcost
state
Command Default None
Command Modes
EXEC mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines The STP port type displays only when you have configured the port as either an STP edge port or an STP
network port. If you have not configured the STP port type, no port type displays.
If you specify an interface that is not running STP, the switch returns an error message.
When you are running MST, this command displays the PVST simulation setting.
Note If you are running MST, use the
interfaces.
Cisco Nexus 5000 Series Command Reference
3-26
show spanning-tree interface {interface slot/port | port-channel number} [active [brief | detail]
| brief [active] | cost | detail [active] | edge | inconsistency | priority | rootcost | state]
Specifies the interface. Use either the type of interface and its slot and port
number, or the EtherChannel number.
(Optional) Displays information about STP active interfaces only on the
specified interfaces.
(Optional) Displays brief summary of STP information on the specified
interfaces.
(Optional) Displays detailed STP information about the specified interfaces.
(Optional) Displays the STP path cost for the specified interfaces.
(Optional) Displays the STP-type edge port information for the specified
interfaces.
(Optional) Displays the port STP inconsistency state for the specified
interfaces.
(Optional) Displays the STP port priority for the specified interfaces.
(Optional) Displays the path cost to the root for specified interfaces.
Current port STP state.
Modification
This command was introduced.
show spanning-tree mst command to show more detail on the specified
Chapter 3 Ethernet Show Commands
OL-16599-01