Enabling Or Disabling Fspf; Clearing Fspf Counters For The Vsan; Fspf Interface Configuration; About Fspf Link Cost - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

FSPF Interface Configuration

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Enabling or Disabling FSPF

To enable or disable FSPF routing protocols, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# fspf enable vsan 7
switch(config)# no fspf enable vsan 5

Clearing FSPF Counters for the VSAN

To clear the FSPF statistics counters for the entire VSAN, follow this step:
Command
Step 1
switch# clear fspf counters vsan 1
FSPF Interface Configuration
Several FSPF commands are available on a per interface basis. These configuration procedures apply to
an interface in a specific VSAN.
This section includes the following topics:
•
•
•
•
•
•
•
•
•
•
•

About FSPF Link Cost

FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database,
and then chooses the path with a minimal cost. The cost associated with an interface can be
administratively changed to implement the FSPF route selection. The integer value to specify cost can
range from 1 to 65,535. The default cost for 1 Gbps is 1000 and for 2 Gbps is 500.
Cisco MDS 9000 Family CLI Configuration Guide
26-6
About FSPF Link Cost, page 26-6
Configuring FSPF Link Cost, page 26-7
About Hello Time Intervals, page 26-7
Configuring Hello Time Intervals, page 26-7
About Dead Time Intervals, page 26-7
Configuring Dead Time Intervals, page 26-8
About Retransmitting Intervals, page 26-8
Configuring Retransmitting Intervals, page 26-8
About Disabling FSPF for Specific Interfaces, page 26-8
Disabling FSPF for Specific Interfaces, page 26-9
Clearing FSPF Counters for an Interface, page 26-9
Chapter 26 Configuring Fibre Channel Routing Services and Protocols
Purpose
Enters configuration mode.
Enables the FSPF routing protocol in VSAN 7.
Disables the FSPF routing protocol in VSAN 5.
Purpose
Clears the FSPF statistics counters for
the specified VSAN. If an interface
reference is not specified, all counters
are cleared.
OL-18084-01, Cisco MDS NX-OS Release 4.x