Fcdroplatency - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

fcdroplatency

To configure the network and switch Fibre Channel drop latency time, use the fcdroplatency command.
To disable the Fibre Channel latency time, use the no form of the command.
Syntax Description
network milliseconds
vsan vsan-id
switch milliseconds
Command Default 2000 millisecond network latency.
500 millisecond switch latency.
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Examples
The following example shows how to configure the network latency to 5000 milliseconds:
switch(config)# fcdroplatency network 5000
The following example shows how to revert to the default switch latency:
switch(config)# no fcdroplatency switch 4000
Related Commands Command
show fcdroplatency
OL-16599-01
fcdroplatency {network milliseconds [vsan vsan-id] | switch milliseconds}
no fcdroplatency {network milliseconds [vsan vsan-id] | switch milliseconds}
Specifies network latency. The range is 500 to 60000.
(Optional) Specifies a VSAN ID. The range is 1 to 4093.
Specifies switch latency. The range is 0 to 60000 milliseconds.
Modification
This command was introduced.
Description
Displays the configured Fibre Channel drop latency parameters.
Cisco Nexus 5000 Series Command Reference
fcdroplatency
8-53