Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 416
Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Release note (26 pages)
Table of Contents
Advertisement
permit (IPv6)
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
IPv6-address/prefix-len
The following example shows how to specify the source argument with the IPv6 address and VLSM
for the 2001:0db8:85a3:: network:
switch(config-acl)# permit udp 2001:0db8:85a3::/48 any
•
Host address—You can use the host keyword and an IPv6 address to specify a host as a source or
destination. The syntax is as follows:
host IPv6-address
This syntax is equivalent to IPv6-address/128.
The following example shows how to specify the source argument with the host keyword and the
2001:0db8:85a3:08d3:1319:8a2e:0370:7344 IPv6 address:
switch(config-acl)# permit icmp host 2001:0db8:85a3:08d3:1319:8a2e:0370:7344 any
•
Any address—You can use the any keyword to specify that a source or destination is any IPv6
address. For examples of the use of the any keyword, see the examples in this section. Each example
shows how to specify a source or destination by using the any keyword.
ICMPv6 Message Types
The icmp-message argument can be the ICMPv6 message number, which is an integer from 0 to 255. It
can also be one of the following keywords:
beyond-scope—Destination beyond scope
•
destination-unreachable—Destination address is unreachable
•
•
echo-reply—Echo reply
•
echo-request—Echo request (ping)
•
header—Parameter header problems
•
hop-limit—Hop limit exceeded in transit
mld-query—Multicast Listener Discovery Query
•
mld-reduction—Multicast Listener Discovery Reduction
•
mld-report—Multicast Listener Discovery Report
•
nd-na—Neighbor discovery neighbor advertisements
•
nd-ns—Neighbor discovery neighbor solicitations
•
next-header—Parameter next header problems
•
no-admin—Administration prohibited destination
•
no-route—No route to destination
•
packet-too-big—Packet too big
•
•
parameter-option—Parameter option problems
•
parameter-problem—All parameter problems
•
port-unreachable—Port unreachable
reassembly-timeout—Reassembly timeout
•
redirect—Neighbor redirect
•
renum-command—Router renumbering command
•
Cisco Nexus 5000 Series Command Reference
6-68
Chapter 6
Security Commands
OL-16599-01
Advertisement
Table of Contents
