Fspf Dead-Interval - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

fspf dead-interval

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fspf dead-interval
To set the maximum interval for which a hello message must be received before the neighbor is
considered lost, use the fspf dead-interval command. To revert to the default value, use the no form of
the command.
Syntax Description
seconds
vsan vsan-id
Command Default 80 seconds.
Command Modes Interface configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines This command is not applicable to virtual Fibre Channel interfaces. This value must be the same in the
ports at both ends of the ISL.
An error is reported at the command prompt if the configured dead time interval is less than the hello
Caution
time interval.
Examples The following example configures the maximum interval of 400 seconds for a hello message before the
neighbor is considered lost:
switch(config)# interface fc 2/1
switch(config-if)# fspf dead-interval 4000 vsan 1
Related Commands Command
show fspf interface
show interface fc
Cisco Nexus 5000 Series Command Reference
8-84
fspf dead-interval seconds vsan vsan-id
no fspf dead-interval seconds vsan vsan-id
Specifies the FSPF dead interval in seconds. The range is 2 to 65535.
Specifies a VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays information for each selected interface.
Displays an interface configuration for a specified Fibre Channel interface.
Chapter 8 Fibre Channel Commands
OL-16599-01