Show Module - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 1 Basic System Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show module

To display module information, use the show module command.
Syntax Description
module-number
fex
chassis_ID
all
Command Default Displays module information for all modules in the switch chassis.
Command Modes
EXEC mode
Command History Release
4.0(0)N1(1a)
4.0(1a)N2(1)
Examples
This example shows how to display information for all modules in the chassis:
switch# show module
This example shows how to display information for a specific module:
switch# show module 2
This example shows how to display information about an attached Fabric Extender:
switch# show module fex 101
This example shows how to display information about all attached Fabric Extender units:
switch# show module fex all
Related Commands Command
show hardware
internal
show inventory
OL-16599-01
show module [module-number | fex [chassis_ID | all]]
(Optional) Number of the module. The valid range is from 1 to 3.
(Optional) Displays information about the attached Fabric Extender units.
(Optional) Specifies a Fabric Extender chassis ID. Chassis ID is 100 to 199.
(Optional) Displays information about all the attached Fabric Extender units.
Modification
This command was introduced.
This command was modified to provide Fabric Extender support.
Description
Displays information about the physical hardware.
Displays hardware inventory information.
Cisco Nexus 5000 Series Command Reference
show module
1-93