Show Interface Private-Vlan Mapping - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 3 Ethernet Show Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show interface private-vlan mapping

To display information about private VLAN mapping for primary VLAN interfaces, use the show
interface private-vlan mapping command.
Syntax Description This command has no arguments or keywords.
Command Default
None
Command Modes
EXEC mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
Before you can configure private VLANs, you must enable them by using the
command. The commands for configuring private VLANs are not visible until you enable private
VLANs.
This command displays the mapping information between the primary and secondary VLANs that
allows both VLANs to share the VLAN interface of the primary VLAN.
Examples This example shows how to display information about primary and secondary private VLAN mapping:
switch# show interface private-vlan mapping
Related Commands Command
feature private-vlan
show interface
switchport
show vlan
show vlan private-vlan Displays information for all private VLANs on the device.
OL-16599-01
show interface private-vlan mapping
Modification
This command was introduced.
Description
Enables private VLANs.
Displays information about the ports, including those in private VLANs,
Displays summary information for all VLANs.
show interface private-vlan mapping
feature private-vlan
Cisco Nexus 5000 Series Command Reference
3-3