Action - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

action

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
action
To specify what the switch does when a packet matches a permit command in a VLAN access control
list (VACL), use the action command. To remove an action command, use the no form of this command.
Syntax Description
drop
forward
Command Default None
Command Modes
VLAN access-map configuration.
Command History Release
4.0(0)N1(1a)
Usage Guidelines The action command specifies the action that the device takes when a packet matches the conditions in
the ACL specified by the match command.
Examples This example creates a VLAN access map named vlan-map-01, assigns an IPv4 ACL named ip-acl-01
to the map, specifies that the switch forwards packets matching the ACL, and enables statistics for traffic
matching the map:
switch(config)# vlan access-map vlan-map-01
switch(config-access-map)# match ip address ip-acl-01
switch(config-access-map)# action forward
switch(config-access-map)# statistics
Related Commands Command
match
show vlan access-map
show vlan filter
statistics
vlan access-map
vlan filter
Cisco Nexus 5000 Series Command Reference
6-10
action {drop forward}
no action {drop forward}
Specifies that the switch drops the packet.
Specifies that the switch forwards the packet to its destination port.
Modification
This command was introduced.
Description
Specifies an ACL for traffic filtering in a VLAN access map.
Displays all VLAN access maps or a VLAN access map.
Displays information about how a VLAN access map is applied.
Enables statistics for an access control list or VLAN access map.
Configures a VLAN access map.
Applies a VLAN access map to one or more VLANs.
Chapter 6 Security Commands
OL-16599-01