Fcroute - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual
Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Release note (26 pages)
Table of Contents
Advertisement
Chapter 8
Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fcroute
To configure Fibre Channel routes and to activate policy routing, use the fcroute command. To remove
a configuration or revert to factory defaults, use the no form of the command.
Syntax Description
fcid
network-mask
interface
fc slot/port
san-port-channel port
vfc vfc-id
domain domain-id
metric number
remote
vsan vsan-id
Command Default
None
Command Modes
Configuration mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
Use this command to assign forwarding information to the switch and to activate a preferred path route
map.
Examples
The following example specifies the Fibre Channel interface and the route for the domain of the next hop
switch for VSAN 2:
switch(config)# fcroute 0x111211 interface fc3/1 domain 3 vsan 2
The following example specifies the SAN port channel interface and the route for the domain of the next
hop switch for VSAN 4:
switch(config)# fcroute 0x111211 interface san-port-channel 1 domain 3 vsan 4
OL-16599-01
fcroute {fcid [network-mask] interface {fc slot/port | san-port-channel port | vfc vfc-id} domain
domain-id {metric number | remote | vsan vsan-id}}
no fcroute {fcid network-mask interface {fc slot/port | san-port-channel port | vfc vfc-id} domain
domain-id {metric number | remote | vsan vsan-id}}
Specifies the FC ID. The format is 0xhhhhhh.
Specifies the network mask of the FC ID. The format is 0x0 to 0xffffff.
Specifies an interface.
Specifies a Fibre Channel interface.
Specifies a SAN port channel interface.
Specifies a virtual Fibre Channel interface.
Specifies the route for the domain of the next hop switch. The range is 1 to
239.
Specifies the cost of the route. The range is 1 to 65535. Default cost is 10.
Configures the static route for a destination switch remotely connected.
Specifies a VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Cisco Nexus 5000 Series Command Reference
fcroute
8-63
Advertisement
Table of Contents
