Vlan Filter - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

vlan filter

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
vlan filter
To apply a VLAN access map to one or more VLANs, use the vlan filter command. To unapply a VLAN
access map, use the no form of this command.
Syntax Description
map-name
vlan-list VLAN-list
Command Default
None
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
You can apply a VLAN access map to one or more VLANs.
You can apply only one VLAN access map to a VLAN.
The no form of this command enables you to unapply a VLAN access map from all or part of the VLAN
list that you specified when you applied the access map. To unapply an access map from all VLANs
where it is applied, you can omit the VLAN-list argument. To unapply an access map from a subset of
the VLANs where it is currently applied, use the VLAN-list argument to specify the VLANs where the
access map should be removed.
Examples This example shows how to apply a VLAN access map named vlan-map-01 to VLANs 20 through 45:
switch(config)# vlan filter vlan-map-01 20-45
Cisco Nexus 5000 Series Command Reference
6-148
vlan filter map-name vlan-list VLAN-list
no vlan filter map-name [vlan-list VLAN-list]
Name of the VLAN access map that you want to create or configure.
Specifies the ID of one or more VLANs whose traffic the VLAN access map
filters.
Use a hyphen (-) to separate the beginning and ending IDs of a range of
VLAN IDs; for example, use 70-100.
Use a comma (,) to separate individual VLAN IDs and ranges of VLAN IDs;
for example, use 20,70-100,142.
Note
Modification
This command was introduced.
When you use the no form of this command, the VLAN-list argument
is optional. If you omit this argument, the switch removes the access
map from all VLANs where the access map is applied.
Chapter 6 Security Commands
OL-16599-01