Scsi-Target - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

scsi-target

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
scsi-target
To configure SCSI target discovery, use the scsi-target command. To remove SCSI target discovery, use
the no form of the command.
Syntax Description auto-poll
vsan vsan-id
discovery
ns-poll
on-demand
Command Default SCSI target discovery for each option is enabled.
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
Automatic global SCSI target discovery is on by default. Discovery can also be triggered for specific
VSANs using on-demand, name server polling, or auto-polling options. All options are on by default.
Use the no scsi-target discovery command to turn off all discovery options. You can also turn off
specific options by using the no form of the command.
Examples The following example configures SCSI target auto-polling discovery for VSAN 1:
switch(config)# scsi-target auto-poll vsan 1
The following example removes SCSI target auto-polling discovery for VSAN 1:
switch(config)# no scsi-target auto-poll vsan 1
The following example configures a SCSI target discovery:
switch(config)# scsi-target discovery
The following example configures SCSI target ns-polling discovery for VSAN 1:
switch(config)# scsi-target ns-poll vsan 1
Cisco Nexus 5000 Series Command Reference
8-128
scsi-target {auto-poll [vsan vsan-id] | discovery | ns-poll [vsan vsan-id] | on-demand [vsan
vsan-id]}
no scsi-target {auto-poll [vsan vsan-id] | discovery | ns-poll [vsan vsan-id] | on-demand [vsan
vsan-id]}
Configures SCSI target auto-polling globally or per VSAN.
Specifies a VSAN ID. The range is 1 to 4093.
Configures SCSI target discovery.
Configures SCSI target name-server polling globally or per VSAN.
Configures SCSI targets on-demand globally or per VSAN.
Modification
This command was introduced.
Chapter 8 Fibre Channel Commands
OL-16599-01