Link Debounce - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

link debounce

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
link debounce
To enable the debounce timer on an interface, use the link debounce command. To disable the timer, use
the no form of this command.
Syntax Description
time milliseconds
Command Default
None
Command Modes Interface configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines The port debounce time is the amount of time that an interface waits to notify the supervisor of a link
going down. During this time, the interface waits to see if the link comes back up. The wait period is a
time when traffic is stopped.
When you enable the debounce timer, link up and link down detections are delayed, resulting in a loss
Caution
of traffic during the debounce period. This situation might affect the convergence of some protocols.
Examples The following example shows how to enable the debounce timer and set the debounce time to 1000
milliseconds for an Ethernet interface:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# link debounce time 1000
The following example shows how to disable the debounce timer for an Ethernet interface:
switch(config-if)# no link debounce
Related Commands Command
show interface
Cisco Nexus 5000 Series Command Reference
2-28
link debounce [time milliseconds]
no link debounce
(Optional) Specifies the extended debounce timer; valid values are from 0 to
5000 milliseconds. A value of 0 milliseconds disables the debounce time.
Modification
This command was introduced.
Description
Displays the interface configuration information.
Chapter 2 Ethernet Commands
OL-16599-01