Logging Module - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

logging module

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
logging module
Use the logging module command to enable module log messages. Set a specified severity level or use
the default.
To disable module log messages, use the no form of this command.
Syntax Description
severity-level
Command Default None
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Examples This example shows how to enable module log messages:
switch(config)# logging module
Related Commands Command
show logging module
Cisco Nexus 5000 Series Command Reference
7-14
logging module [severity-level]
no logging module
(Optional) The number of the desired severity level at which messages
should be logged. Messages at or numerically lower than the specified level
are logged. Severity levels are as follows:
•
•
•
•
•
•
•
•
Modification
This command was introduced.
Description
Displays the module logging status.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition—default level
6—informational: Informational message only
7—debugging: Appears during debugging only
Chapter 7 System Management Commands
OL-16599-01