Show Flogi - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 9 Fibre Channel Show Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show flogi

To list all the fabric login (FLOGI) sessions through all interfaces across all VSANs, use the show flogi
command.
Syntax Description auto-area-list
database
fcid fcid-id
interface
fc slot/port
vfc vfc-id
vsan vsan-id
Command Default None
Command Modes EXEC mode.
Command History Release
4.0(0)N1(1a)
Usage Guidelines The output of this command is sorted by interface numbers and then by VSAN IDs.
In a Fibre Channel fabric, each host or disk requires an FCID. Use the show flogi database command
to verify if a storage device is displayed in the fabric login (FLOGI) table as in the examples below. If
the required device is displayed in the FLOGI table, the fabric login is successful. Examine the FLOGI
database on a switch that is directly connected to the host HBA and connected ports.
Examples
The following example displays details on the FLOGI database:
switch# show flogi database
The following example displays the FLOGI interface:
switch# show flogi database interface fc 2/3
OL-16599-01
show flogi {auto-area-list} | database {fcid fcid-id | interface {fc slot/port | vfc vfc-id} | vsan
vsan-id}
Displays the list of Organizational Unit Identifiers (OUIs) that are allocated
areas.
Displays information about FLOGI sessions.
Displays FLOGI database entries based on the FCID allocated. The format
is 0xhhhhhh.
Displays FLOGI database entries based on the logged in interface.
Specifies the Fibre Channel or virtual Fibre Channel interface by slot and
port number.
Specifies a virtual Fibre Channel interface.
Displays FLOGI database entries based on the VSAN ID. The range is 1 to
4093.
Modification
This command was introduced.
Cisco Nexus 5000 Series Command Reference
show flogi
9-29