Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 689
Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Release note (26 pages)
Table of Contents
Advertisement
Chapter 8
Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Command Modes
Configuration mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
To use this command, change to the VSAN database mode.
The interface range must be in ascending order and nonoverlapping. You can specify a range using a
hyphen and several interfaces using commas:
•
•
There are four interop modes:
•
•
•
•
Examples
The following example shows how to create multiple fabrics sharing the same physical infrastructure and
how to assign ports to VSANs:
switch(config)# vsan database
switch-config-vsan-db# vsan 2
switch(config-vsan-db)# vsan 2 name TechDoc
switch(config-vsan-db)# vsan 2 loadbalancing src-dst-id
switch(config-vsan-db)# vsan 2 loadbalancing src-dst-ox-id
switch(config-vsan-db)# vsan 2 suspend
switch(config-vsan-db)# no vsan 2 suspend
switch(config-vsan-db)# end
The following example shows how to suspend a VSAN and enable Interop mode 4:
switch(config)# vsan database
switch(config-vsan-db)# vsan 100 suspend
switch(config-vsan-db)# vsan 100 interop 4
switch(config-vsan-db)# exit
OL-16599-01
Modification
This command was introduced.
The interface range format for a Fibre Channel interface range is
fcslot/port - port , fcslot/port , fcslot/port:
For example,
show int fc2/1 - 3 , fc2/4 , fc3/2
The format for a SAN port channel is
san-port-channel portchannel-number.subinterface-number:
For example,
show int san-port-channel 5.1
Interop mode 1 — Standards based interop mode that requires all other vendors in the fabric to be
in interop mode.
Interop mode 2 — Brocade native mode (Core PID 0).
Interop mode 3 — Brocade native mode (Core PID 1).
Interop mode 4 — McData native mode. Before you configure Interop mode 4 (or remove the
configuration), you must suspend the VSAN. You should unsuspend the VSAN only after you
configure a VSAN-dependent switch WWN with the McData OUI [08:00:88].
Cisco Nexus 5000 Series Command Reference
vsan database
8-141
Advertisement
Table of Contents
