Show Vpc Consistency-Parameters - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 10 Vpc Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show vpc consistency-parameters

To display the consistency of parameters that must be compatible across the virtual port-channel (vPC)
interfaces, use the show vpc consistency-parameters command.
Syntax Description global
interface
port-channel
channel- number
vpc number
Defaults None
Command Modes Any command mode.
Command History Release
4.1(3)N1(1)
Usage Guidelines The show vpc consistency-parameters command displays the configuration of all the vPC Type 1
parameters on both sides of the vPC peer link.
All the Type 1 configurations must be identical on both sides of the vPC peer link, or the link will not
Note
come up.
The vPC Type 1 configuration parameters are as follows:
•
•
•
•
•
•
OL-16599-01
show vpc consistency-parameters {global | interface port-channel channel-number | vpc
number}}
(Optional) Displays the configuration of all Type 1 global parameters
on both sides of the vPC peer link.
(Optional) Displays the configuration of all Type 1 interface
parameters on both sides of the vPC peer link.
(Optional) Displays the configuration of all Type 1 interface
parameters on both sides of the vPC peer link for the specified vPC.
Modification
This command was introduced.
Port-channel mode: on, off, or active
Link speed per channel
Duplex mode per channel
Trunk mode per channel
Native VLAN
–
– VLANs allowed on trunk
– Tagging of native VLAN traffic
Spanning Tree Protocol (STP) mode
STP region configuration for Multiple Spanning Tree
show vpc consistency-parameters
Cisco Nexus 5000 Series Command Reference
10-9