Match Protocol - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

match protocol

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
match protocol
To configure a class map to use a specific protocol as a match criterion, use the match protocol
command. To remove the specified protocol as a match criteria, use the no form of this command.
Syntax Description
not
protocol-name
Defaults None
Command Modes Class-map type qos configuration
Command History Release
4.1(3)N1(1)
Usage Guidelines The list of valid protocol names is shown in
Table 3
Argument
arp
bridging
cdp
clns
clns_es
clns_is
dhcp
isis
ldp
netbios
Note A maximum of eight different of the above protocols can be matched at one time.
Cisco Nexus 5000 Series Command Reference
5-14
match [not] protocol protocol-name
no match [not] protocol protocol-name
(Optional) Negates the specified match result.
Matches on the specified protocol name. Valid values are shown in
Table
Modification
This command was introduced.
Protocol Names
Description
Address Resolution Protocol (ARP)
Bridging
Cisco Discovery Protocol (CDP)
Connectionless Network Service (CLNS)
CLNS End Systems
CLNS Intermediate System
Dynamic Host Configuration (DHCP)
Intermediate system to intermediate system
(IS-IS)
Label Distribution Protocol (LDP)
NetBIOS Extended User Interface (NetBEUI)
3.
Table 3.
Chapter 5 Quality of Service Commands
OL-16599-01