Zone Clone - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

zone clone

To clone a zone name, use the zone clone command.
Syntax Description
current-zone-name
new-zone-name
vsan vsan-id
Command Default None
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Use the no form of the zone name (configuration mode) command to delete the zone name.
Examples The following example creates a clone of the original zone group named origZone into the clone zone
group cloneZone on VSAN 45:
switch(config)# zone clone origZone cloneZone vsan 45
Related Commands Command
show zone
OL-16599-01
zone clone current-zone-name new-zone-name vsan vsan-id
Clones a zone attribute group from the current name to a new name.
Maximum length of names is 64 characters.
Specifies the VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays zone information.
Cisco Nexus 5000 Series Command Reference
zone clone
8-145