Show Startup-Config Interface - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show startup-config interface

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show startup-config interface
To display interface configuration information in the startup-configuration, use the show startup-config
interface command.
Syntax Description ethernet slot/port
expand-port-profile
loopback number
port-channel
channel-number
membership
tunnel number
vlan vlan-id
Defaults None
Command Modes
Any command mode.
Command History Release
4.1(3)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the information in the startup configuration for the interface Ethernet
7/1:
switch(config)# show startup-config interface ethernet 7/1
version 4.1(2)
interface Ethernet7/1
ip pim sparse-mode
Related Commands Command
show interface
Cisco Nexus 5000 Series Command Reference
10-4
show startup-config interface [ethernet slot/port | expand-port-profile | loopback number |
mgmt0 | port-channel {channel-number} [membership] | tunnel number | {vlan vlan-id}
Number of the module and port number.
Shows port profiles.
Number of the loopback interface. The range of values is from 1 to 4096.
Number of the port-channel group. The range of values is from 0 to 1023.
Membership of the specified port channel.
Number of the tunnel interface. The range of values is from 0 to 65535.
Number of the VLAN. The range of values is from 1 to 4096.
Modification
This command was introduced.
Description
Displays information about the specified interface.
Chapter 10 Vpc Commands
OL-16599-01