Match Cos (Class Map Type Queuing) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

match cos (class map type queuing)

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
match cos (class map type queuing)
To define the class of traffic in a type queuing class map, use the match cos command. To remove the
match configuration, use the no form of these commands.
Syntax Description
cos-list
Defaults
None
Command Modes Class-map type queuing configuration
Command History Release
4.1(3)N1(1)
Usage Guidelines To specify a list of values, use one of the following options:
•
•
Only class maps of type qos support the optional not keyword form of this command.
Note
This command does not require a license.
Examples This example shows how to modify a type queuing class map to match on CoS:
switch(config)# class-map type queuing match-any 8q2t-in-q4
switch(config-cmap-que)# match cos 3
switch(config-cmap-que)#
Related Commands Command
show class-map
Cisco Nexus 5000 Series Command Reference
5-8
match cos cos-list
no match cos cos-list
Matches on the specified COS value or list of specified CoS values. Valid values
are from 0 to 7.
Modification
This command was introduced.
Specify a range of values separated by a dash
Specify a noncontiguous list of values separated by commas
Description
Displays class maps.
Chapter 5 Quality of Service Commands
OL-16599-01