Reload - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

reload

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
reload
To reload the switch and all attached Fabric Extender chassis or a specific Fabric Extender, use the
reload command.
Syntax Description all
fex chassis_ID
Command Default
Reloads the Cisco Nexus 5000 Series switch.
Command Modes EXEC mode
Command History Release
4.0(0)N1(1a)
4.0(1a)N2(1)
Usage Guidelines The reload command disrupts traffic on the switch and Fabric Extender.
The reload command does not save the running configuration. Use the copy running-config
Note
startup-config command to save the current configuration on the device.
Examples This example shows how to reload the Cisco Nexus 5000 Series switch:
switch# copy running-config startup-config
switch# reload
This command will reboot the system. (y/n)?
This example shows how to reload a Fabric Extender:
switch# reload fex 101
WARNING: This command will reboot FEX 101
Do you want to continue? (y/n) [n] y
Related Commands Command
copy running-config
startup-config
show version
Cisco Nexus 5000 Series Command Reference
1-66
reload {all | fex chassis_ID}
Reboot the entire Cisco Nexus 5000 Series switch and all attached Fabric
Extender chassis.
Reboot a specific Fabric Extender chassis. Chassis ID is 100 to 199.
Modification
This command was introduced.
Support for the Cisco Nexus 2000 Series Fabric Extender was added.
Description
Copies the current running configuration to the startup configuration.
Displays information about the software version.
Chapter 1
[n] y
Basic System Commands
OL-16599-01