Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 760
Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Release note (26 pages)
Table of Contents
Advertisement
show zone
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
The following example displays zone information for a specific VSAN:
switch# show zone vsan 1
The following example displays members of a specific zone:
switch# show zone name Zone1
The following example displays all zones to which a member belongs using the FCID:
switch# show zone member pwwn 21:00:00:20:37:9c:48:e5
The following example displays the number of control frames exchanged with other switches:
switch# show zone statistics
The following example displays the status of the configured zones:
switch# show zone status
The following example checks the status of the zoneset distribute vsan command and displays the
default zone attributes of a specific VSAN or all active VSANs:
switch# show zone status vsan 1
VSAN:1 default-zone:deny distribute:active only Interop:default
mode:basic merge-control:allow session:none
hard-zoning:enabled
Default zone:
qos:low broadcast:disabled ronly:disabled
Full Zoning Database :
Zonesets:0
Active Zoning Database :
Database Not Available
Status:
Table 9-3
Table 9-3
Field
VSAN:
default-zone:
Default zone:
distribute:
Interop:
mode:
merge control:
Hard zoning is
enabled
Full Zoning Database:
Active Zoning
Database:
Status:
Cisco Nexus 5000 Series Command Reference
9-52
Zones:0 Aliases:0
describes the significant fields shown in the show zone status vsan display.
show zone status Field Descriptions
Description
VSAN number displayed.
Default-zone policy either permit or deny.
The Default zone field displays the attributes for the specified VSAN. The
attributes include: Qos level, broadcast zoning enabled/disabled, and
read-only zoning enabled/disabled.
Distribute full-zone set (full) or active-zone set (active only).
Displays interop mode. 100 = default, 1 = standard, 2 and 3 = Non-Cisco
vendors.
Displays zoning mode either basic or enhanced.
Displays merge policy either allow or restrict.
If hardware resources (TCAM) becomes full, hard zoning is automatically
disabled.
Displays values of zone database.
Displays values of active zone database.
Displays status of last zone distribution.
Chapter 9
Fibre Channel Show Commands
OL-16599-01
Advertisement
Table of Contents
