Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 290

show spanning-tree vlan
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
inconsistentports
interface slot/port |
port-channel number
cost
edge
inconsistency
priority
rootcost
state
port
summary
Command Default None
Command Modes EXEC mode
Command History Release
4.0(0)N1(1a)
Examples This example shows how to display STP information on VLAN 1:
switch# show spanning-tree vlan 1
Related Commands Command
show spanning-tree
show spanning-tree
active
show spanning-tree
bridge
show spanning-tree
brief
show spanning-tree
detail
Cisco Nexus 5000 Series Command Reference
3-34
((Optional) Displays the ports that are in an inconsistent STP state for
specified VLANs.
(Optional) Specifies the interface. Use either the type of interface and its slot
and port number, or the EtherChannel number.
(Optional) Displays the STP path cost for the specified VLANs.
(Optional) Displays the STP-type edge port information for the specified
interface for the specified VLANs.
(Optional) Displays the STP port inconsistency state for the specified
interface for the specified VLANs.
(Optional) Displays the STP priority for the specified VLANs.
(Optional) Displays the path cost to the root for specified interfaces for the
specified VLANs.
Current port STP state. Valid values are blocking, disabled, learning, and
forwarding.
(Optional) Displays information about the root port for the specified
VLANs.
(Optional) Displays summary STP information on the specified VLANs.
Modification
This command was introduced.
Description
Displays information STP.
Displays information about STP active interfaces only.
Displays bridge ID, timers, and protocol for the local bridge on the switch.
Displays brief summary information about STP.
Displays detailed information about STP.
Chapter 3 Ethernet Show Commands
OL-16599-01