Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 431

Chapter 6 Security Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
username name
timeout seconds
Command Default
Accounting port: 1813
Authentication port: 1812
Accounting: enabled
Authentication: enabled
Retransmission count: 1
Idle-time: 0
Server monitoring: disabled
Timeout: 5 seconds
Test username: test
Test password: test
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines When the idle time interval is 0 minutes, periodic RADIUS server monitoring is not performed.
Examples
This example shows how to configure RADIUS server authentication and accounting parameters:
switch(config)# radius-server host 10.10.2.3 key HostKey
switch(config)# radius-server host 10.10.2.3 auth-port 2003
switch(config)# radius-server host 10.10.2.3 acct-port 2004
switch(config)# radius-server host 10.10.2.3 accounting
switch(config)# radius-server host radius2 key 0 abcd
switch(config)# radius-server host radius3 key 7 1234
switch(config)# radius-server host 10.10.2.3 test idle-time 10
switch(config)# radius-server host 10.10.2.3 test username tester
switch(config)# radius-server host 10.10.2.3 test password 2B9ka5
Related Commands Command
show radius-server
OL-16599-01
Specifies a username in the test packets. The maximum size is 32 characters.
Specifies the timeout (in seconds) between retransmissions to the RADIUS
server. The default is 1 second and the range is from 1 to 60 seconds.
Modification
This command was introduced.
Description
Displays RADIUS server information.
Cisco Nexus 5000 Series Command Reference
radius-server host
6-83